Last updated: 23 November 2006
The following 3mm scale test etches in 0.010" nickel silver are currently being evaluated. If you are interested in any of these please email john@jswalker.demon.co.uk.
Go back to 3mm Kits I am developing
This etch is still under development. It is designed to be pegged and soldered to a dummy PCB tiebar which can be hidden within 1/8" cork underlay. The dummy tiebar can then be covered with a piece of card which is ballasted to match the surrounding track. As John Bateman has demonstrated on Wadebridge you don't notice that the ballast actually moves when the point is changed! The slot in the brackets is designed to take a strip of 0.005" plasticard to represent the prototype bar. The trial assembly was done by John.
Go back to Parts for Track and Signalling
This etch is designed to fit the lost wax cast ground signal post which is under development by John Bateman. There are several parts to be added to the etch.
Go back to Parts for Track and Signalling
Go back to 3mm Kits I am developing